Command Tips: Curve
Create the path and guide curves first when sweeping so that that the profile appears at the right point in history to apply Pierce relations.
Part | Path,Guide Curve,Sweep
Part | Path,Guide Curve,Sweep
Get curve position data into a table with a curve driven pattern. Create a hole at the end of the curve, then pattern the hole - a thousand? - times. Create a drawing and place a hole table to get the dimensions of the holes along the curve.
Part,Drawing | Pattern,Curve
Part,Drawing | Pattern,Curve
Know that you don't need a sketch (2d or 3d) to draw a curve. You can use Curve>Curve Through Reference Points
Sketch,Reference | Curve
Sketch,Reference | Curve
See the UV mesh of a surface using the Face Curves command.
Surface | Face Curve
Surface | Face Curve
Use an equation to drive a feature via Insert>Curve through XYZ Points. Create a file of XYZ points (use a spreadsheet if you like), then Load File. You could use a sine curve for a sweep.
Part | Curve,Sweep
Part | Curve,Sweep